
How to Choose a Rock Loader for Underground Mining?
Choose a rock loader by matching its working clearance, power supply and travel arrangement to your mine, then check the bucket and receiving mine car together. Bucket volume alone is not enough to select equipment for underground loading.

Check the tunnel and the full loading movement
Record tunnel width and height, gradient and the space available at the loading face. A machine’s overall dimensions describe its body; the bucket needs additional room as it lifts and unloads. Compare the working envelope with the tunnel profile before choosing a model.
For example, HNYT lists the ZQ-17 at 2,230 × 1,360 × 1,390 mm overall, with a tunnel reference of at least 1.7 × 2.0 m. These are different measurements. Review the published ZQ-17 specifications alongside the actual roadway layout.
Match the drive to the available power
Pneumatic rock loader
A pneumatic rock loader needs compressed air at the machine. Confirm both pressure and flow at the working position, including losses through the supply line. Hose length, diameter, leakage and other tools using the network can affect the available supply.
The ZQ-17 product page lists a working-pressure range of 0.45–0.7 MPa. Treat this as a model reference, not a universal setting for every air loader. Check the selected machine’s air requirements before confirming an order.
Electric rock loader
An electric rock loader is an option where the site can provide the required electrical supply. Confirm voltage, frequency, electrical protection and cable routing. The cable arrangement must remain clear of the rails and moving structure; compare these requirements with the mine’s installation conditions.

Choose rail or rubber-wheel travel
For rail-mounted loading, confirm gauge, track condition, curves and gradient. The ZQ-17 lists 600, 762 and 900 mm gauge options. Select the configuration that matches the mine railway rather than treating these options as interchangeable on site.
Where loading positions are not served by rails, consider a rubber-wheel machine such as the ZQW-13. Review floor condition, slope, turning space and access to the receiving equipment. Freedom from rails does not remove the need to check operating clearance and ground conditions.
Match the bucket to material and haulage
In this single-bucket layout, the machine collects broken material at the front, lifts it and unloads toward receiving equipment behind the machine. Check the rock size, bucket arrangement and discharge path against the loading task.
Compare mine-car dimensions with the selected loader’s unloading height and working position. The ZQ-17 page lists a 0.17 m³ bucket and 1,260 mm unloading height. These values help define the interface; bucket volume by itself does not establish the output of the complete loading and haulage system.

FAQ
Is tunnel height the same as machine height?
No. Overall height describes the machine body. Selection also requires space for bucket movement and discharge, so check both the tunnel profile and the working envelope.
Should every mine choose pneumatic drive?
No. A pneumatic model requires suitable compressed-air pressure and flow at the machine. An electric model requires the specified electrical supply, protection and cable arrangement. Compare both with the site’s available services.
What should I confirm before choosing a rail-mounted model?
Confirm track gauge and condition, curves, gradient, tunnel clearance and the receiving mine car. Review these together with the selected model’s working dimensions and power requirements.
Discuss your loading requirements
Send HNYT your tunnel dimensions, gradient, material size, required output, rail gauge or floor conditions, available power and mine-car dimensions. Include a layout or site photographs so the proposed rock loader can be reviewed against your loading and transport arrangement.







